How do you maintain a weed sprayer so it lasts?

Quikspray agricultural spray unit mounted on utility vehicle, showing tank, hose reel and pump assembly in field setting

Quick answer

Flush the tank, pump and hoses after every job, run a cleaning solution such as Quik Flush through the whole system each week, and service the engine and pump before each spray season. Before storing it, clean it thoroughly and protect it from frost. Chemical residue left in the system is the main thing that wears out seals, diaphragms and hoses early.

Every job
rinse with clean water
Weekly
Quik Flush through the system
1 bottle
Quik Flush per 50 L
10 min
circulate on bypass

Why does cleaning matter so much?

Agricultural chemicals attack rubber. Residue left in the tank, pump or hose slowly hardens and cracks diaphragms, seals and O-rings. It can also contaminate your next job if you switch herbicides. Regular flushing protects both your equipment and your results.

Engine, pump and twin hose reels on a Quik Spray spray unit

Weed sprayer maintenance checklist

WhenWhat to do
After every jobRinse the tank with clean water and flush it through the pump, hose and gun. Dispose of rinsate away from waterways and catchments, following the chemical label
WeeklyRun Quik Flush through the full system so every part that touches chemical is cleaned and lubricated
RegularlyCheck filters, nozzles, O-rings, the spray gun and hose for wear. These consumables wear in normal use
Before each seasonService the engine and pump, check pressure, and test the full hose length and the remote
Before storageClean thoroughly, drain the system and store it under cover, protected from frost

How do I flush a spray unit with Quik Flush?

Quik Flush is Quik Spray’s pump and tank cleaner. It rinses and lubricates internal parts and reduces chemical damage to rubber components.

Quik Flush pump and tank cleaner bottles
1
Rinse.Fill the tank with clean water and discharge it to remove most of the residue.
2
Mix.Add one bottle of Quik Flush to 50 L of water in the tank.
3
Circulate.Run the pump on bypass for ten minutes so the solution flows through the pump and back into the tank.
4
Push it through.Pressurise the system, open the spray gun and run the tank dry, so the solution passes through the hose and out the gun.
5
Final rinse.Rinse the tank with clean water and discharge again.

Use clean water free of clay or organic matter, as these can deactivate some chemicals and cause blockages. Always follow the chemical label, as some products need a specific cleaning agent. Order Quik Flush from the Quik Spray parts store.

Does maintenance affect my warranty?

Yes. Using Quik Flush from the first day of use extends the Bertolini pump warranty from 6 months to 24 months. You may need to show evidence of use if you make a claim.

Damage from freezing, unauthorised repairs and non-approved parts is not covered. See the warranty policy and our guide to the lifetime tank warranty.

How should I service my spray unit before the season?

✓
Engine.Follow the service schedule in your Honda or Kohler engine manual. If your unit has electric start, never pull-start it, as this can permanently damage the radio control board.
✓
Pump.Check for leaks and steady pressure. Diaphragms and valves are wear parts, so replace them before they fail mid-job.
✓
Hose and reel.Pull out the full length and look for cracks, flat spots and leaks. Check the swivel and roller guides. Our hose reel roller guides post explains why they matter.
✓
Remote.Test the retract function across your usual working distance. The troubleshooting guide covers common causes of reduced range.
✓
Calibration.Recheck your rate with the weed sprayer calibration guide and the nozzle guide.

If you’d rather hand it over, book a service through a Quik Spray service centre. Manuals and info sheets are on the manuals page, and the video support hub shows common jobs step by step.

Twin Quik Spray hose reels loaded with blue Supa-Slip hose

How should I store a weed sprayer over the off-season?

  • Flush with Quik Flush and rinse before storage. Never store a unit with chemical in it.
  • Drain the pump, lines and hose so no water sits in them. Freeze damage to tanks, pumps, hoses and filters is not covered by warranty.
  • Store under cover, out of direct sun.
  • Keep the remote handset dry and away from chemicals.

Need parts or a service?

Shop genuine parts at the Quik Spray parts store or call 1800 645 688 for advice.

Frequently asked questions

How often should I clean my weed sprayer?

Rinse it with clean water after every job and run a cleaning solution such as Quik Flush through the full system at least once a week.

How do I get chemical residue out of a spray tank?

Rinse with water, then circulate a cleaning solution through the tank, pump, hose and gun before a final rinse. Some chemicals need a specific cleaning agent, so check the label.

How much Quik Flush do I use?

One bottle of Quik Flush to 50 L of water, run on bypass for ten minutes, then pushed through the hose and gun.

What parts of a sprayer wear out first?

Consumables such as diaphragms, O-rings, seals, filters, nozzles, spray guns and hoses wear with normal use. Regular flushing slows that wear.

Can I leave water in my sprayer over winter?

No. Drain the pump, lines and hose. Freezing can crack tanks, pumps and hoses, and freeze damage isn’t covered by warranty.

Leave a Reply

Your email address will not be published. Required fields are marked *